1、Specification:1800mm
2﹑Type: left-hand machine(facing coating driving on the left)
3﹑Speed: 5-30m/min
4、Wallboard: depth for composite place is δ: 30mm made by steel plate
Depth for coating place is δ: 100mm made by cast iron
5﹑Specification for bearing support : Φ55mm
6、Rubber roller: a. composite place adopts Φ390×1800 1piece
b. Coating place adopts Φ200×1600 1piece
7、Heating roller: adopt spec:Φ350mm×1820mm (plate Teflon on surface)
Heating method: adopt 9*2kw electric heated tube conducting the heat by heat transfer oil
Temperature control: adopt thermocouple close beta test, matching with intelligent temperature controller
8、Driving type: adopt frequency control of motor speed, synchronous controller adjusts the whole machine in step
a. Composite place: adopt 3kw motor, 1:35 cycloid reducer
b. Coating place: adopt 2.2kw motor, 1：17 cycloid reducer
c. Winding place: adopt 1.5kw motor, 1：17 cycloid reducer
d. Parting place: adopt 1.5kw motor, 1：17 cycloid reducer
e. Cloth draw-out place: adopt 0.75kw motor, 1：17 cycloid reducer
9、Rubber roller and heating roller adopt cylinder to control UP and DOWN, and intake pressure range: 0~0.45Mpa
a. Cylinder spec for composite place: Φ250×120mm 2pcs
b. Cylinder spec for coating place: Φ80×125mm 2pcs
10、Oven: a. Overall dimension: 5600×2200×880mm
b. Heater: adopt two sets heating fans and air flues which deliver only hot air
c. Power: fan 0.37 kw/set, heating case 18×1kw heater case
d. One side surface: matching with 3 small doors
Note: the six surfaces of oven are made by double-layer cooling steel plate with thermal insulation material in between with depth as δ：20mm
11. Running roller adopts aluminum alloy, spec: Φ80×1900mm
12. Friction winding roller spec: Φ165×1900mm 4 pcs
13. Cloth draw-out roller spec: Φ120×1850mm 1 pc
14. Releasing shaft spec: adopt 2 pcs of air shafts and matching with magnetic powder for controlling tension
15. Winding shaft spec: Φ45×2450mm
16. Material plate: match with 2 stainless- steel standard material plates
17. Opening roller 2 pcs, releasing shaft 1 pc, winding shaft 2 pcs
Note: the power supply and air supply for this machine shall be provided by the buyer
